EasyManua.ls Logo

Truma Combi 4E CP plus - User Manual

Truma Combi 4E CP plus
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Combi 2 E / 4 E CP plus (Australia)
Operating instructions Page 2 Installation instructions
Page 9
To be kept in the vehicle!
Question and Answer IconNeed help?

Do you have a question about the Truma Combi 4E CP plus and is the answer not in the manual?

Truma Combi 4E CP plus Specifications

General IconGeneral
Heating TypeGas and Electric
Heating power (Gas mode)4 kW
Rated heat output in gas mode3800 W
Operating pressure30 mbar
Water capacity10 litres
Safety FeaturesOverheat protection

Summary

Function Description and Operating Modes

Function Description

Explains the Truma Combi 2 E / 4 E CP plus heater and its capabilities.

Safety Instructions

Provides essential safety precautions for using the appliance.

Safety Warnings and Operating Notes

Gas Leak and Safety Procedures

Instructions for handling gas leaks and general safety.

Important Operating Notes

Key points to observe for safe and correct operation.

Maintenance, Safety Features, and Troubleshooting

Overheating Protection 240 V

Explains the 240V overheating protection and reset.

Faults and Troubleshooting Guide

Lists common faults and provides troubleshooting steps for water supply.

Technical Specifications and Warranty

Truma Warranty Policy

Details the warranty terms, conditions, and exclusions.

Installation Guidelines and Important Notices

Installation Instructions Overview

Emphasizes careful reading of installation instructions.

Regulatory Compliance and Location Selection

Selecting an Installation Location

Guidance on choosing the optimal and safe location for the unit.

Device Securing and Exhaust System Installation

Securing the Device to the Vehicle

Instructions for securely mounting the heater unit.

Installing the Wall Cowl and Duct Lengths

Guides for installing the wall cowl and permissible duct lengths.

Airflow and Gas Connections

Connecting Exhaust Double Duct

Steps for connecting the exhaust double duct to the unit.

Gas Connection Requirements

Details the gas pressure regulator and inlet connection.

Water and Gas Connections

Gas Pipe Sizing and Leak Testing

Covers gas pipe routing, sizing, and leak testing procedures.

Water Connection and Pump Requirements

Details connecting water pumps and requirements for water lines.

Sensor and Control Panel Installation

Electrical Connections

Guide to making electrical connections to the unit.

Power Supply and Final Checks

12 V Voltage Supply

Guidance on connecting the 12V power supply.

240 V Voltage Supply

Instructions for expert connection of the 240V power supply.

Function Test and Warnings

Steps for testing functions and applying warning stickers.

Related product manuals