What to do if water pressure is too high in Truma Heater?
If the water pressure is too high in your Truma Heater, check the pump pressure, which should be max. 2.8 bar. If your boiler is connected to a central water supply, ensure a pressure reducer is used to prevent pressures exceeding 2.8 bar.
Why does Truma Heater FrostControl open automatically at low temperatures?
At temperatures of less than approximately 3 °C, the FrostControl opens automatically. Switch the heater on. Without heater operation, the FrostControl cannot be closed again until the temperature reaches approximately 7 °C. Alternatively, use a heating element for FrostControl.
What to do if Truma Heater boiler cannot be drained?
If the Truma Heater boiler cannot be drained even when the safety/drain valve is open, check the safety/drain valve drainage socket for blockage. Remove any soiling such as slush, ice, or leaves if necessary.
Why does Truma Heater FrostControl open after switching off?
If the FrostControl opens after the Truma Heater has been switched off, it is because the temperature at the FrostControl is less than approximately 7 °C. To resolve this, switch the heater on. Without heater operation, the FrostControl cannot be closed again until the temperature reaches approximately 7 °C.
How to fix Truma Heater when rotary switch is not set to 'Operation'?
Turn the rotary switch of the FrostControl to 'Operation', then press the pushbutton until it engages.
What to do if Truma Heater water takes too long to heat?
If the water in your Truma Heater is taking an extremely long time to heat up, the water container may be furred. Descale the water system, referring to the maintenance instructions.
What to do if water is running away and Truma Heater boiler cannot be filled?
If water is running away and the Truma Heater boiler cannot be filled, the safety/drain valve may be open. Close the safety/drain valve.
Immediate actions to take if a gas smell is detected to ensure safety.
Guidelines for ensuring a safe environment around the heater unit.
Key principles for operating the appliance safely, especially regarding gas supply.
General| Fuel | Gas/Electric |
|---|---|
| Water capacity | 10 litres |
| Water heating time | 20 - 30 minutes |
| Weight (without peripherals) | 16.5 kg |
| Voltage | 12 V / 230 V |
| Water Heating Capacity | 10 Liters |
| Gas consumption | 160 – 480 g/h |
To Next Page
