EQUIPMENT DETAILS
114
9. Cleaning and care
Do not use abrasive cleaning agents or hard
objects during cleaning as these can damage
the refrigerator. Never use hard or pointed
tools to remove ice or to loosen objects which
have frozen in place.
As soon as the refrigerator becomes dirty,
clean it with a damp cloth. Make sure that no
water drips into the seals. This can damage
the electronics. Wipe the refrigerator dry with a
cloth after cleaning.
10. Guarantee
Our general guarantee conditions apply. If the
product is defective, please return it to the
WAECO branch in your country or to your
dealer. For repair and guarantee processing,
please include the following documents when
you send in the appliance:
• A copy of the receipt with purchasing date
• Reason for the claim or a description of
the fault
11. Disposal
Place the packaging material in the appropriate
recycling waste bins wherever possible.
If you wish to scrap the appliance, ask your
local recycling centre or specialist dealer for
details about how to do this in accordance
with the applicable disposal regulations.
12. Troubleshooting
The significance of the red LED (7)
For operational faults it illuminates several
times. The number of pulses depends on the
type of fault.
Each flash lasts for one quarter of a second.
After the series of impulses a pause follows.
The sequence for the fault is repeated every
four seconds.
No. of
flashes
Fault Possible cause
1 Supply
voltage
The supply voltage
is outside of the
set range.
2 Excessive
fan current
The fan loads the
electronics unit
with more than 1 A
3 The motor
doesn’t start
The rotor is
jammed.
The pressure
difference in the
cooling system is
too high
(> 5 bar).
4 Speed too
low
If the cooling
system is
overloaded, the
minimum speed of
the motor of 1850
RPM cannot be
maintained.
5 Overheating
of the
electronics
unit
If the cooling
system is loaded
too heavily or the
temperature is
set too high, the
electronics can
overheat.
WAECO FRIDGE
To Next Page
Loading...
Need help?
General
