EasyManua.ls Logo

Truma DuoControl CS - Troubleshooting; 7 Troubleshooting

Truma DuoControl CS
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DuoControl CSTroubleshooting
56 EN
50020-00980 ∙ 00 ∙ 08/2022
The user must arrange for the gas system to be tested in accordance
with the relevant national regulations (e�g� in Germany every 2 years)
by a liquid gas expert� The test must be confirmed on the respective
test certificate (G 607)�
In countries where testing is not mandatory, it is advisable to have the
gas system tested every 2 years for your own safety
7 Troubleshooting
Fault rectification measures are listed below� If the measures are not
successful, contact Truma Service�
The following points must be checked if there are problems with the
gas supply:

Check the fill level of the gas cylinder

Check that the cylinder valve is opened�

Check the hose rupture protection* if one is in use�

Check whether the switchover system is set/adjusted correctly

Check whether the crash sensor was triggered (see chapter
„Crash sensor (CS)“)�

Check whether the quick-acting shut-o valves on the gas appli-
ances (heating, oven, gas hob, etc�) are open�
The gas pressure regulator may ice up at temperatures around 0
°C� If the gas pressure regulator ices up, the gas flow is reduced or
completely interrupted� To ensure an uninterrupted gas supply at low
temperatures, Truma also oers the EisEx regulator heater
8 Accessories
High-pressure hoses
with hose rupture protection and country-specific connections, see
www�truma�com

Table of Contents