MonoControlInstallation and connection
18 EN
50020-00990 ∙ 00 ∙ 08/2022
4.2 Installation location
When selecting a suitable position for the gas pressure regulator, the
following points must be observed:
•
The gas pressure regulator must be installed in a protected en-
vironment that is not exposed to moisture, sunlight or dust�
•
The gas pressure regulator is intended for installation in the gas
locker of the caravan or motor home�
•
The gas pressure regulator contains a pressure relief valve (PRV),
which is used to relieve temporary overpressure in the gas
system� To prevent dangerous gas from accumulating, the gas
pressure regulator must be installed in a well-ventilated space�
Ventilation must be guaranteed at all times�
•
All parts of the gas system must be securely fastened to sturdy
structures to prevent damage due to vehicle vibrations while
driving�
•
The gas pressure regulator must be assembled on a sturdy wall or
ceiling with at least 2 screws arranged diagonally�
•
The type plate (print) on the gas pressure regulator should be
legible when installed�
•
The reset button should be easy to recognise and access�
•
The reset button must not be blocked�
•
Select the installation position so there is enough space when
changing the cylinder to avoid damage�
•
Select the installation position so that the test connection is easily
accessible for the leak test�
•
The gas pressure regulator must be installed in such a way that
the high-pressure hose connection is in the highest possible
location, which must be at least higher than the cylinder valve
level� See broken line in figure� If installation takes place below
the cylinder valve, gas in the liquid phase can penetrate into the
gas pressure regulator, damage sensitive parts and lead to gas
escaping in an uncontrolled manner� Operating situations such as
the vehicle being on an incline or heating while driving must be
taken into account�
To Next Page
Loading...
Need help?
General
