Why are lights blinking when my Truper Air Compressor is operating?
Lights may be blinking due to: * **Voltage drops:** Double-check the feeding line voltage, the fuses, or correct the motor overload. * **Energy regulation issues:** There may be an energy deficient regulation (unbalanced line). Consult with a qualified electrician.
What to do if my Truper COMP-60LB is not reaching its speed?
If the compressor isn't reaching its normal speed, consider these possibilities: * **Voltage drops:** Double-check the feeding line voltage, the fuses or correct the motor overload. * **Energy regulation issues:** There may be an energy deficient regulation (unbalanced line). Consult with a qualified electrician. * **Faulty check valve:** Inspect for leaks. If the valve needs replacing, visit a TASC.
What to do if there is abnormal piston, worn ring or cylinder in my Truper Air Compressor?
If you notice abnormal piston wear, a worn ring, or cylinder issues, it could be due to: * **Low oil viscosity:** Change the oil and use the correct type. * **Low oil level:** Add oil to the casing up to the correct level. * **Dusty environment:** You may need a more effective filter in the air admission.
What to do if the motor is not running on my Truper COMP-60LB Air Compressor?
If the motor isn't running, there are several potential causes: * **Voltage drops:** Double-check the feeding line voltage, fuses, or correct the motor overload. * **Energy regulation issues:** There may be an energy deficient regulation (unbalanced line). In this case, consult with a qualified electrician. * **Capacitor problems:** If it's a monophasic unit, the capacitor might be faulty or damaged. Ask for a motor capacitor check-up at a TASC. * **High tank pressure:** Ensure the tank pressure isn't higher than the cutting pressure of the switch. The motor will restart when the tank pressure drops below the cutting pressure. * **Failing check valve:** Check for leaks. If the valve needs replacing, go to a TASC. * **Overload triggered:** Press the thermic button to restart th...
General| Model | COMP-60LB |
|---|---|
| Max Pressure | 125 PSI |
| Voltage | 120 V |
| Frequency | 60 Hz |
| Maximum Pressure | 125 PSI |
| Motor Type | Induction |
| Amperage | 15 A |
| Pump Type | Oil-Free |
| Horsepower | 3.7 HP |
To Next Page
