What to do if Truper DES-63 motor is not reaching full speed and starts having smoke emissions?
If your motor isn't reaching full speed and is emitting smoke, it could be related to the fuel or spark arrest screen. Ensure you are using new fuel and the correct oil mix for a 2-stroke motor. If this doesn't solve the issue, the spark arrest screen may be dirty, and you will need to contact a service center.
What to do if Truper Lawn and Garden Equipment motor starts but will not accelerate?
If the motor starts but won't accelerate, give it a few minutes to warm up completely. If it still won't accelerate after three minutes, you will need to contact a service center.
What to do if Truper Lawn and Garden Equipment motor starts, runs, accelerates but there is no idle speed?
If the motor starts, runs, and accelerates, but there's no idle speed, the idle screw in the carburetor likely needs adjustment. Turn the idle screw clockwise to increase the speed.
Why Truper DES-63 Lawn and Garden Equipment motor starts but runs only in high speed with half a choke?
If the motor starts but only runs at high speed with half a choke, the carburetor probably needs adjustment. You will need to take the Gas Brushcutter to a service center for this adjustment.
Why Truper DES-63 Lawn and Garden Equipment motor does not start?
There are several reasons why the motor might not be starting. It could be due to a lack of spark. To check this, remove the motor cover, take out the spark plug, connect the spark plug cable, and set the spark plug onto the motor cylinder, ensuring the metal part touches the cylinder. Pull the jack-line and watch for a spark in the spark plug electrode. If there's no spark, try again with a new spark plug. Another reason could be a lack of fuel. Press the starter choke until you see fuel in the bulb. If fuel isn't visible, the primary system in the fuel supply may be blocked, and you will need to contact a service center. Lastly, the motor might be flooded. If so, turn the switch off, remove the spark plug, move the choke lever downwards, and pull the jack-line 15 to 20 times to get rid o...
Safe handling of fuel and oil for the brushcutter.
Pre-operation checks, attire, and work area preparation.
Safe operation, body posture, and hazard awareness.
Post-operation procedures, cooling, and storage.
Attaching the handle to the brushcutter shaft.
Securing the protective guard to the cutter head.
Mounting cutting blades or circular saws.
Installing the cutting line spool.
Fitting and adjusting the operator's harness.
Adjusting the harness for proper tool balance.
Starting the engine from a cold state.
Starting the engine when warm.
Safely turning off the brushcutter engine.
Cleaning exterior and cooling vents.
Cleaning and maintaining the air filter.
Checking and replacing the fuel filter.
Carburetor adjustment and its importance.
Inspecting, honing, and maintaining the cutting blade.
Replacing the spark plug and specifications.
Cleaning exhaust system and muffler.
Lubricating the cutting head gearbox.
Storing the brushcutter for extended periods.
General| Brand | Truper |
|---|---|
| Model | DES-63 |
| Category | Lawn and Garden Equipment |
| Language | English |
To Next Page