1 liter
1L
+ =
50:1
ratio
Mix
4 capfuls oil
Gasoline
• The Gas Brushcutter runs with an air-cooled two-cycle engine and uses a mix of unleaded gasoline and high quality,
self-mixing motor oil with fuel stabilizer specified for air-cooled -2 stroke motor.
• The motor is certified to run with unleaded gasoline for vehicles having an octane index of 87 ([R+M]/2) or higher.
• Do not use any type of gasoline and oil mix sold in Service stations, especially, used in motorcycles.
• Do not use motor oil for self-propulsion, or two-cycle oil outboard motor.
• The ratio for the mix shall be 50 parts gasoline per 1 part oil (50:1 Ratio). Prepare the mix in an approved fuel container.
Always mix thoroughly before pouring it into the motor fuel tank.
Do not use a fuel mix that has been sored longer than 7 days. Mix small quantities.
Never smoke near the fuel or where fuel is being supplied, or in the oil-gasoline mix preparing site or
when operating the brush trimmer.
Trying to start the Gas Brushcutter without mixing oil into the fuel will cause a faulty motor.
Code
Description
Net Weight
Motor
Motor Rated Power
Fuel Tank
Speed
Cutting Capacity
Axis Length
DES-63
12671
22 lb
Gas Brushcutter
0.34 gal
3 HP
9000 RPM
17”
59”
Cutting Systems
Type of handle
Work Cycle
Nylon Thread Spool, Blades and Circular Saw (not included)
“Bicycle” Type
20 minutes’ rest per each tank consumed.
Maximum 6 hours.
63 cc
Technical data
Fuel Specifications
To extend the motor’s useful life use synthetic oil for 2-stroke motors.
* 1 gallon = 3.78 liters ** Not included
A wrong mix may cause the Gas Brushcutter to throw a rod
causing expensive repairs!
WARNING
WARNING
CAUTION
3
ENGLISH
Use ACES-2, ACES-5 or ACES-20 oil caps** to measure the mix.
Mix 4 capfuls oil per each gasoline liter.
To Next Page
Loading...