Secure Web Gateway 11.5 Setup Guide
Copyright © 2013 Trustwave Holdings, Inc. All rights reserved. 17
Disables the snmpd network service. Enter the disable_service_snmpd command.
Disables the ssh network service. Enter the disable_service_ssh command.
Enables the network service. The enable command includes the enable_service_snmpd and
enable_service_ssh commands.
Enables the snmpd network service. Enter the enable_service_snmpd command.
Enables the ssh network service. Enter the enable_service_ssh command.
Enables configuring the Network Interface parameters.
Enter the ethconf command and choose the required interface. Choose the required speed or select Auto-
negotiation to enable the appliance to negotiate its own speed.
Enter the ethconf command and choose the interface, for example, enter 1 (eth1).
The settings for the selected interface are displayed.
Choose configuration for the adapter and confirm to make the settings permanent
Note: According to the IEEE 802.3 standard, when working with 1000Base-T at a speed of 1000Mbps,
auto-negotiation must be enabled. A fixed speed of 1000Mbps is not supported. For more information,
refer to the 1000BASE-X Auto-Negotiation standard as defined in Clause 37 of the IEEE 802.3 standard.
Flushes the dns cache.
Rebuilds the appliance configuration in extreme situations where the appliance, for whatever reason, was
disconnected for a period of time. This action restarts the appliances and may take several minutes.
To Next Page