• To prevent accidents, strictly follow the procedures and cautions noted in this manual.
Safety information for the prevention of danger is given in "1. ON SAFETY" in this manual.
• A warning label marked (electrical shock) is affixed to the servo amplifier front panel.
•
•
•
•
Very serious accidents may occur if this instruction is not observed.
Do not turn on the machine's power supply until all the noted precautions have
been studied and understood.
This manual provides general guidelines, precautions and warnings for the safe operation of this machine.
Please be sure to deliver this instruction manual to all administrators and operators charged with the
operation of this machine.
They must carefully read this manual and fully understand its contents, and should not let anyone who is
not familiar with the contents of this manual operate or inspect this machine.
Keep this manual available near the equipment at all times so that it can be immediately referred to
whenever necessary.
Look up the name, address and phone number of our nearest dealer or branch office listed on the back
page of this manual, and post the information prominently for quick reference.
All machine operators must read "1. ON SAFETY" in this manual carefully
and thoroughly.
WARNING
From Chapter 2, safety information is given for any task or operation that is potentially dangerous and each
of these messages is prefaced with the appropriate signal word.
Be careful to avoid injury from shock, as electrical circuits are incorporated in the area near this label. (See
pages 5-1,3)
If this machine is used in ways other than those described in this manual, unforeseen problems or accidents
may occur, and we shall bear no liability or responsibility for the consequences.
This manual contains important information you must know about the AR series servo system, which
consists of a servo actuator and a servo amplifier, its safety features, and necessary operating precautions.
Be sure to read it thoroughly before attempting to transport, install, wire, operate, service or inspect the
servo system.
?
To Next Page
Loading...
Need help?
General