- Preface -
4. Exporting the servo system
5. Product warranty
6. Usage liability
7. Copyright
© 2000: TS
The copyright for this entire manual belongs to Teijin Seiki Co., Ltd. Copying, reprinting or reproduction of this
manual in whole or in part in any media without our express consent infringes upon the copyright and the rights
of the publisher.
The data noted in this manual is only offered as sample reference data for normal usage of this machine.
We shall bear absolutely no liability or responsibility for the consequences if this machine is utilized for
purposes other than those described in this manual.
We assume no responsibility or liability for any damage or consequential and/or indirect losses resulting from
any accident or malfunction that might occur during the operation of this machine.
We shall not be held responsible for any damage caused by conditions beyond our control such as customer
modifications, disassembly or misuse of our products, or their use in a defective or deficient environment.
We shall not bear any legal responsibility for its suitability for each customer's particular uses nor shall we be
held liable for any incidental or indirect damages caused by usage of the machine itself.
However, we will not bear incidental costs, such as man-hours required to remove from and/or install to the
equipment, transportation costs, taxes, warehouse charges, etc.
We shall also not compensate losses resulting from the stoppage of any equipment that incorporates the servo
system due to problems caused by the servo system.
If we make financial compensation for the product, the maximum amount of the compensation shall not exceed
the sales price of the applicable product.
Please note that machine specifications are subject to change without notice for updates and improvements. This
may cause inconsistencies between the contents of this manual and the machine you currently possess.
When incorporating the servo system into its machines, each industrial equipment manufacturer must carefully
observe all the procedures and cautionary notes included in this manual to prevent injuries or accidents caused
by its improper installation or operation.
International transfer of this machine, any of its parts, components and/or software must be carried out in
compliance with the relevant laws and ordinances of the country of export and the country of equipment end-
use.
We do not assume any responsibility or liability for equipment transferred without regard to proper
export/import regulations or procedures.
The term of warranty on the servo system is either one year from installation or 2000 running hours after
incorporation into the equipment, whichever is shorter, under condition that proper setup and wiring have been
carried out in accordance with the ratings we stipulate.
?
To Next Page
Loading...
Need help?
General