Manual of Mid-drive Conversion Motor——TSDZ8
Document No.：TSE-PM-MM-TSDZ8-A-01(EN)
Suzhou Tongsheng Electric Appliances Co., Ltd 8 / 11
7) After tightening the "locking nut", drag the motor with your hand and tighten the fixing plate
screws completely with the hexagonal wrench (locking torque 10N. m).
8) Install the " cover of locking nut ": tighten the "locking nut cover" with locking wrench (locking
torque 10-15N. m).
9) Assemble the cranks: Tighten the crank screws with the M8 hexagonal wrench (locking torque:
35-40N.m). Note: Pay attention to the left and right markings on the crank arm. Do not assemble
the left or right crank at the wrong position. Otherwise, it may cause personal injury.
4.2 Kits Installation
To Next Page
Loading...