APPENDIX B
Firmware Commands
B-1
This appendix provides a quick reference and description of
firmware commands.
Commands—Quick Reference
RD Read Display concentration
RL Read Laser
RRA Read Record raw Analog
RRC Read Record Control
RRD Read Record Data
RRS Read Record Status
RTO Read Time On
RV Read Version
SAS Set Absolute pressure Scale factor
SD Set Dryer on/off
SDC Set Dead-time Correction value
SDM Set Drain Mode
SDO Set Detector Offset
SDT Set Detector Threshold
SFS Set Flow Set point
SFZ Set F
low Zero value
SG Set Growth heater on/off
SGS Set Growth tube temperature Set point
SHS Set sHeath flow Set point
SIP Set Injection Prime
SIT Set Injection Time interval
SL Set Laser on/off
SLM Set Live-time Minimum value
SLS Set Laser Set point
SM,x,t Set Mode x=mode t=sample time
SO Set Optics heater on/off
SOS Set Optics temperature Set point
SP Set Pump on/off
SS Set Saturator temperature controller on/off
SSS Set Saturator temperature Set point
SV Set analog Voltage output
SVS Set analog
Voltage Span value
SVZ Set analog Voltage Zero value
SZ Set auto Zero function
To Next Page
Loading...
