Operation 3-7
Setup Tab
The setup tab provides access to the following:
Identify and save the location information associated with
collected samples.
Save a group of settings (a recipe) that you use over and
over so you don’t have to reset individual settings.
Sets which units are preferred for displaying
environmental measurements taken using optional
measurement probes.
Change Power On Password, Setup Password, System
Configuration, Print Settings, Print Schedule and Clear
Samples.
Purge residual particles from flow path.
Display instrument information such as model number,
firmware version, serial number, etc.
Set Date and Time, Screen Alignment, Communications,
Regional Settings, and get device information.
To Next Page
Loading...
