S afety First
Regardless of how enthusiastic you may be about getting on
your equipment and exercising, take the time to ensure that
your safety is not jeopardized. A moment’s lack of attention
can result in an accident, as can failure to observe certain
simple safety precautions.
1. Read, study and understand the Owner’s Manual and all
the warning labels on this product. Furthermore, it is
recommended to familiarize yourself and others with the
proper operation and workout recommendations for this
Tuff Stuff product prior to use. Some of this information
can be obtained in this Owner’s Manual, as-well-as from
your local Tuff Stuff retailer.
2. It is imperative that you retain this Owner’s Manual and be
sure all warning labels are legible and intact.
Replacement Owner’s Manuals and labels are available
from your local Tuff Stuff retailer.
3. Consult with your physician before beginning any exercise
program.
Safety Precautions
CFM-550 Compact Frontal Machine
2
4. Use proper discretion when children are present.
5. Frayed or worn cables can be dangerous and may cause
injury. Periodically check these cables for any indication
of wear.
6. Keep hands, limbs, loose clothing and long hair well out of
the way of moving parts.
7. Do not attempt to lift more weight than you can control
safely.
8. Inspect the Compact Frontal Machine for any sign of wear
on parts, hardware becoming loose or cracks on welds. If
a problem is found do not use or allow the machine to
be used until the defective part is repaired or replaced.
9. Pay special attention to the Push Pull Pins 1/2 X 3-1/2
(#38) located on the Press Bar Selector Housing (#7),
and the Front Upright (#5), also the Turn/Pull Pin w/
Knob (#39) located on the Leg Extension Bench Frame
(#4). See Fig.1. Be sure they are fully engaged into the
selected holes. Refer to Fig. 2, 3 for further illustration of
this instruction.
Fig. 1 Illustration above depicts the location of the Push Pull Pins 1/2”
X 3-1/2 (#38) and the Turn/Pull Pin w/Knob (#39) on this unit.
Turn/Pull Pin
w/Knob (#39)
Push Pull Pin
1/2 X 3-1/2 (#38)
Turn/Pull Pin w/Knob
Fully Engaged
Fig. 3 Caution: Check the Turn/Pull Pin w/Knob (#39) to be fully
engaged into the selected hole of the Bench Press Adj. Seat Tube (#9).
Fig. 2 Caution: Check that the two Push Pull Pins 1/2 X 3-1/2 (#38)
located on the Press Bar Selector Housing (#7), and the Front Upright
(#5) are fully engaged into the selected holes of the Press Bar (#6), and
the Back Pad Bracket (#12).
Push Pull Pin
1/2 X 3-1/2
Fully Engaged
Push Pull Pin
1/2 X 3-1/2 (#38)
To Next Page
Loading...
