26
Attaching the Legs
1. Position the first Leg (C) below the Side Rail
(A or B) as shown in the picture.
2. Ensure the holes on the Leg are on the same
side as the hole on the Side Rail.
3. Insert the Leg and move it to the desired
position.
4. Insert the Leg Screw into the hole and use the
Assembly Tool to tighten it.
5. Repeat Steps 1-4 for each Leg. En sure all Legs
are set to the same height.
1
CAUTION
Risk of minor or moderate injury through cutting
Contact with sharp edges may lead to minor or moderate injury
from cutting.
C
A B
To Next Page
Loading...
