30
5
Preparing the Control Box
1. Insert the 4 Motor Cables from the Side Rails
(A, B) into the Plug Ports on the Control Box
(I). Ensure that the color of the Plug matches
the color of the Plug Port.
2. Insert the Power Converter Cable (J) into the
Control Box. Lay the Cable flat along the floor
to reduce the risk of tripping.
DO NOT CONNECT SYSTEM BEFORE FINISHING ASSEMBLY
CAUTION
Risk of minor or moderate injury through crushing
While screwing in the Crossbar Knobs, you will need to lift the
moving parts of the Side Rails. Allowing these parts to fall may
lead to minor or moderate injury through crushing.
• Ensure moving parts do not fall down during assembly
CAUTION
Risk of minor or moderate injury through crushing
Gripping the Side Rails’ moving parts may lead to minor or
moderate injury through crushing.
• Do not touch moving parts when lifting or moving the Side Rails.
Only grip the fixed parts
H
I
J
J
J
I
To Next Page
Loading...
