48
Behavior
Remote lights up but the Bed Frame does not
respond when Buttons are pressed.
Remote does not light up. The Bed Frame does
not respond when Buttons are pressed.
Remote Control defective or lost.
Parts of the Bed Frame do not move evenly.
Possible Cause/Solution
1. The Bed Frame is not connected properly. Check the
power connection
2. Time-out has been reached due to continuous operation.
Do not operate the Bed Frame for at least 6 minutes. This will
reset the time-out.
3. Unplug the Power Converter. Wait until the LED goes out,
then plug it back in.
Replace the batteries in the Remote Control.
Press the Button on the Power Converter until the Bed Frame is
in the Sleeping Position.
Make sure no persons or heavy objects are on the Bed Frame or
in the range of moving parts.
The Bed Frames may be misaligned. Follow the instructions in the
section “Fixing Misalignment” to realign the Bed Frames.
To Next Page
Loading...
