49
Behavior
Parts of the Bed Frame remain in an elevated
position after a power failure.
Remote Control defective or lost.
Parts of the Bed Frame do not move evenly.
Possible Cause/Solution
If power cannot be restored, an Emergency Lowering is required.
Proceed as follows:
1. Unplug the Power Converter from the mains
2. Remove the cover of the Power Converter (see Diagram A on
next page).
3. Insert two 9V batteries into the Power Converter. Do not use
rechargeable batteries.
4. Make sure no heavy objects or any person is on the bed or in
the range of moving parts.
5. Press the Button on the Power Converter until the Bed Frame
reaches the flat position (see Diagram B on next page).
After this action, the batteries must be replaced. If you store batteries
in the power supply as a backup, they must be replaced annually.
Make sure no persons or heavy objects are on the Bed Frame or
in the range of moving parts.
The Bed Frames may be misaligned. Follow the instructions in the
section “Fixing Misalignment” to realign the Bed Frames.
To Next Page
Loading...
