4 5
NOTE! Use the enclosed Allen key to tighten both
fastening screws through the holes in the tube. Tighten the
fastening screws by turning them counter-clockwise.
CONSOLE
Connect the cables from the handlebar to the
corresponding connectors of the console. Insert the
connected cables into the console, but make sure they
are not damaged when the console is attached. Place
the meter in position at the end of the handlebar support
tube and attach the console using 4 mounting screws.
SEAT
Loosen the seatholder locking screw and turn the upper
locking lever so that it is aligned with the equipment.
Place the seat into position on the grooves of the lower
locking lever. Turn the upper locking lever towards the top
of the seat rails and lock the seat by tightening the locking
screw.
POWER CORD
Plug the socket end of the transformer cord into the
connector, just above the rear support in the centre of the
frame, and the other end into the wall socket. To prevent
damage to the connector, we recommend you tie the
cord to the transportation wheel support next to the
connector.
NOTE! Do not use extension wires when connecting
the device to the power source. Make sure the power
cord does not run underneath the device.
Always switch off the power and uplug this appliance
from the electrical outlet immediately after using.
ADJUSTMENTS
ADJUSTING THE SEAT
Set the right height for you; the basic rule is that the arch
of the foot reaches reaches the the pedal at its lowest
point with the leg almost straight. Adjust the seat height
by loosening the seat locking knob. Hold on to the seat
with one hand and, using your other hand, pull the
locking knob outwards in order to enable free seat tube
movement upwards and downwards. Once the height is
right, let go of the knob and the seat locks into place. Turn
the locking knob clockwise to tighten.
NOTE! Always make sure that the locking knob is
properly fastened before starting to exercise!
To adjust the horizontal seat position forward and back,
loosen the locking screws under the seat. You can also
adjust inclination from here. Release the seat lock by
turning the locking lever located under the seat anti-
To Next Page
Loading...
