Tunturi E504 - Page 7

PULSE: Use this key to turn the
pulse function on or off. When the
pulse function is on, a heart-shaped
symbol will be displayed in the LCD
window and will flash in rhythm with
your pulse. In addition, a tone will
sound if your heart rate exceeds the
preset upper pulse limit. {Refer to
Pulse Set mode and SET key.)
MODE: Use this key to step through
the five modes displayed in the LCD
window when the unit is stopped. In
start mode, this key will step through
Speed, Time, Dis and Pulse modes.
When you begin your workout, the
electronics module automatically
selects the SPEED mode. Pressing
the MODE key moves the arrow in
the LCD window one position to the
left. Modes are always selected in
sequence.
Scan Function: if you hold down
the MODE key for two seconds, the
speed, time, distance, and pulse
modes will be displayed at five sec¬
ond intervals in the LCD window
throughout your workout session.
The word SCAN will appear in the
LCD window.
Speed Mode: Calculates miles per
hour (mile/h) from 0 to 99.99. The
speed bar graph shows the revolu¬
tions per minute (RPM x 100) from 0
to 700 RPMs. The speed bar graph
is always displayed in the LCD win¬
dow regardless of other modes you
may have selected.
Time Mode: Tracks the elapsed
time of each exercise session from 0
to 99 minutes. If you preset your
workout time, the electronics mod¬
ule will begin to count down. The
remaining time will be displayed in
the LCD window (refer to SET key).
Dis Mode: Tracks the distance trav¬
eled during each exercise session
from 0 to 99.99 miles.
Pulse Mode: Tracks your heart rate
during an exercise session. The
outer edge of uie heart-shaped sym¬
bol will flash in rhythm with your
pulse.
Pulse Set Mode: Tracks your heart
rate during an exercise session and
compares it to a preset upper limit. A
tone sounds when your pulse ex¬
ceeds the preset pulse during an ex¬
ercise session.
RESET: Use this key to set one or all
of the mode values to zero (0). Press
the RESET key to set the current
value of the mode displayed in the
LCD window to zero (0) and switch
the unit to STOP, Press and hold the
RESET key to set ail mode values to
zero (0) and switch the electronics
module to STOP.
LCD Window:
When you first turn on the electron¬
ics module, the LCD window lights
up and you will see a variety of sym¬
bols displayed. These symbols indi¬
cate that the electronics module is
working. The symbols displayed and
their significance are described in
more detail in the section titled
“Keys” above.
6