Maintenance
The only parts which may be replaced are fuses.
All other operations must be carried out by the manufacturer.
Scrapping
Dispose of properly after use. Dispose of the product according to laws in force for
electronic equipment.
This device is for use in a dust collection system and is therefore part of a fixed
installation.
Default Settings
The default settings are:
Function
Number
Description Set value
F01 Automatic setting using dP (1) or manual (0) 1
F02 Solenoid valve activation time
0.20”
F03
Washing pause time between solenoid valves in normal
cycle
020”
F04 Number of outputs 1
F05 Output voltage: 24 Vdc, 24 Vac, 115 Vac, 230 Vac. 24 Vac
F06 Manual solenoid valve activation 1
F07 Zero dP threshold 0 kPa
F08 Cycle start dP threshold 0.80 kPa
F09 Cycle stop dP threshold 0.40 kPa
F10 Max. dP level 3.00 kPa
F11 Fan mode: 0 from contact , 1 from dP 1
F12 Fan dP threshold (if F11 = 1). If < fan off 0.10 kPa
F13 Number of cycles after fan stop 1
F14 Pause time between solenoid valves in cycle with fan off
010”
F15 Maintenance frequency in 10h (1=10h, 100=1000h) 100
F16 Maintenance deadline alarm on (1) or off (0) 0
F17
Maintenance hour counter reset: set 1 and confirm to reset
the maintenance hour counter
0
F18 Precoating on (1) or off (0) 0
F19 Precoating dP threshold (if F18 = 1). 2.00 kPa
F20
Enabling Minimum dP Alarm function.
0
F21
Min dP Alarm Threshold (Broken Sleeve/Cartridge)
0.20 kPa
F22
Cleaning Cycle Forced (only available in operating
mode F01 = 2)
Set if it handled in minutes or if in hours.
0
F23
Setting the interval time in relation to the choice of F22
240
F24
Exclusion of valve in short circuit.
0
To Next Page
Loading...
Need help?
General
