Turbo E2T Series User Manual

5
Display / Keypad
There are four round buttons on the front panel for controlling the device and
turning on the display as shown in the following figure.
 The SET button enables to enter and exit the
programming menu, and activate the manual
testing of select4ed solenoid valve function F06.
 The + and – buttons enable to scroll functions
from F01 to Fxx. After entering one of the Fxx
functions use the OK button to select and then +
and - increase or decrease the values.
 The OK button is used to confirm data and reset
alarms.
 If the + button is pressed during ordinary
operation, the activity hour meter is displayed.
 The - Button pressed during the ordinary
operation, displays the counts partial hours of
activity.
Menu Diagram
 Press SET, the letter F flashes.
 Press + and – to select the required function.
 Press OK to confirm.
 Increase or decrease the value of the parameter.
 Holding down the + and - buttons to scroll through
all the functions until the end of the left or right.
 Press OK to confirm and exit.
 Press SET again to exit programming mode.

Turbo E2T Series Specifications

General

Brand	Turbo
Model	E2T Series
Category	Controller
Language	English