Operation
14 14
D. CHANGING THE MOISTURE SETTING.
Press and hold ‘Steam’ key for 3 seconds.
Rotate ‘Temp’ knob to select desired moisture level (H-0 to H-5).
Press ‘Steam’ key to confirm settings.
NOTE: Refer to ‘Moisture Mode Settings’ at start of this section for additional explanation of moisture level adjustments.
E. VIEWING ACTUAL OVEN TEMPERATURE / ACTUAL CORE PROBE TEMPERATURE.
Press ‘Temp’ key during cooking. Oven Set Temperature will display on Upper Display for 2 seconds, then Actual Temperature
will display on Upper Display for 2 seconds. At the same time, Actual Core Probe temperature will display on Lower Display
for 4 seconds. After 4 seconds, controller will revert to displaying the program number.
F. ADDING MORE TIME TO A STAGE WHEN THE END OF STAGE ALARM IS SOUNDING.
At the end of a stage, provided that ‘ALr’=On, an end of stage alarm will sound for 1 minute before automatically progressing on to the
next stage of the program. While alarm is sounding, additional cooking time can be added to the stage that has just finished.
Rotate and hold ‘Timer’ knob for 3 seconds to enter Timer Edit Mode and add time to the stage.
When the length of time required has been added, either;
- Press ‘Timer-Start/Stop’ key to resume the stage,
OR
- Wait for the auto-resume feature to progress the oven on to the next stage, 1 minute after alarm initially sounded.
When the additional time has run out, the end of stage alarm will sound for a second time. Either press ‘Timer-Start/Stop’ key
to progress on to the next stage, or let the program automatically progress on to the next stage after 1 minute of inactivity.
G. TURNING THE LIGHTS ‘ON/OFF’.
Whenever the oven is ‘On’ the ‘Light’ key is used to turn the oven lights ‘On/Off’. To extend bulb life, an auto time-out can be
pre-set to switch oven lights ‘Off’ after a set length of time. The factory default for time-out is ‘Off’ (‘0’, ie lights remain ‘On’
until light key is pressed again). This time-out can be activated by setting the operator settings L-0 from 1-60 minutes.
NOTE: Any changes will only apply to the current stage. Following stages will revert to the programmed settings.
To Next Page
Loading...
Need help?
General