Turtle Beach Ear Force Stealth 400 - Audio Device and Output Settings; Audio Multi-Output Configuration

13
PS3™ Setup
Go to Table of Contents
7. Go to Settings > Sound Settings > Audio Output
Settings > Optical Digital.
8. In the check-off boxes, select ONLY Linear PCM 2
CH. 44.1kHz and Linear PCM 2 CH. 48 kHz.
9. Go to Settings > Sound Settings > Audio Multi
Output.
10.Select On.
5. In the PS3 menus, go to Settings > Accessory
Settings > Audio Device Settings.
6.SettheInputDeviceandOutputDeviceeldsto
Turtle Beach STEALTH 400 Chat.
Audio Device Settings
Microphone Level 3
Input Device Turtle Beach Stealth 400 Chat
Output Device Turtle Beach Stealth 400 Chat
Back
X Enter
OK
Audio Output Settings
Select an output format supported by the TV or AV amplifier (receiver) in use. The system will
automatically adjust the output to match the selected format.
Dolby Digital 5.1 Ch.
DTS 5.1 Ch.
AAC
Linear PCM 2CH. 44.1 kHz
Linear PCM 2 Ch. 88.2 kHz
Linear PCM 2 Ch. 176.4 kHz
Linear PCM 2 Ch. 48 kHz
Cancel
X Enter
Audio Output Settings
12/14 12:15 PM
0
On
Sets to output audio through multiple connectors
simultaneously. Audio output to connectors that are
not selected in [Audio Output Settings] is downscaled
to 2 Ch.