Turtle Beach Ear Force Stealth 400 - Pairing the Headset and Transmitter

15
Pairing the Headset and Transmitter
Go to Table of Contents
The STEALTH 400 Wireless Transmitter sends audio and chat between your game console and
 yourHeadsetviadigitalradiofrequencysignal,soadirectlineofsightisnotrequired.Whenthe 
headset and transmitter are communicating, the Connection Status LED on the Wireless
Transmitter will stay lit.
NOTE: Your STEALTH 400 Headset ships from the factory already paired for communication with
your Wireless Transmitter. In normal operation, it should not be necessary for you to pair the two
again. You should only need to perform pairing yourself in the event that wireless communication
fails. First check that the headset is powered on and is within range. If the Connection Status LED
on the Wireless Transmitter is still pulsing, the Wireless Transmitter can’t communicate with
the Headset. Perform the following pairing procedure.
3.PressandholdthePowerButtonontheHeadsetuntiltheheadsetCharge/PairingStatusLEDashes  
rapidly and the Headset announces “Pairing.”
4. Within 5-10 seconds, the Connection Status LED on the Transmitter will remain lit, while the Charge/Pairing
 StatusLEDontheHeadsetwillashoncepersecond.TheHeadsetwillalsoannounce“HeadsetPaired”to 
 conrmthatpairingwassuccessful.
2. The Pair Button on the Transmitter is recessed in a pinhole to prevent accidental operation. Insert a paperclip
 intothepinholeuntilthetransmitter’sConnectionStatusLEDashesrapidly.
1.TheHeadsetshouldbepoweredOFF.Ifit’son,pressandholdthePowerButtonontherightearcupforve
seconds.