Need help?Do you have a question about the Tuthill GG130 and is the answer not in the manual?
General| Pump Model | GG130 |
|---|---|
| Type | Gear Pump |
| Pressure | 100 PSI |
| Housing Material | Cast Iron |
| Seal Type | Mechanical Seal |
| Maximum Pressure | 100 PSI |
| Series | GG |
| Material | Cast Iron |
| Power Source | Electric |
Explains the internal gear design pumping principle and how it achieves positive-displacement.
Lists specifications and models for the GG Series pumps, including size, speed, capacity, and pressure.
Provides guidelines for proper pump installation, including suction line, placement, and piping.
Outlines lubrication needs for bearings and bushings.
Procedures for removing packing or single seals from the pump.
Steps for installing single and cartridge mechanical seals.
Specific removal steps for different seal types (in-board, out-board, cartridge).
Instructions for installing in-board and out-board single mechanical seals.
Detailed procedure for adjusting the end clearance of the pump.
Instructions for adjusting the pressure setting of the relief valve.
Troubleshooting steps for when the pump delivers no fluid.
Troubleshooting steps for low pump capacity.
To Next Page