Operator’s Manual 2020 0217 ENG
12
03
Installation
FILL PLUGS
SIGHT GLASSES
Fill to center
while parked on a
level surface.
MAGNETIC
DRAIN PLUGS
Always on bottom
of blower
HORIZONTAL AIR FLOW
(STANDARD)
VERTICAL AIR FLOW**
(OPTIONAL)
** If installing a T850 blower for vertical air fl ow (optional), additional oil than what is included with the blower
will be needed for installation. Tuthill PneuLube is available from your authorized Tuthill Truck Blower
Distributor.
Figure 3-4 – Oil Fill Locations
HORIZONTAL
AIR FLOW
(STANDARD)
VERTICAL
AIR FLOW
(OPTIONAL)
Drive end 0.75 qt (0.71 L) 1.2 qt (1.1 L)
Non-drive
(gear) end
0.63 qt (0.60 L) 1.1 qt (1.0 L)
Table 3-2 – Lubrication Capacities
OTE: N Oil capacities are based on fi lling from
dry condition. Less oil may be needed
depending on emptiness of oil reservoirs
after draining.
To Next Page
