10
LVM-071W
· Aperture
This item controls the picture sharpness.
#Sharpness can be adjusted by using the [APERTURE] control knob on the front of
the monitor.
· NTSC Setup
This item sets IRE value in NTSC mode between 0 IRE and 7.5 IRE.
[2] PICTURE (DVI Analog Only)
· Brightness
This Item controls the degree of brightness.
#Brightness can be adjusted by using the [BRIGHT] control knob on the front of the
monitor.
· Contrast
This item controls the contrast ratio.
#Contrast can be adjusted by using the [CONTRAST] control knob on the front of the
monitor.
· Image Position
This item controls the position(H/V) of the image in DVI Analog mode.
· Phase
This item controls Phase value.
To Next Page
Loading...
Need help?
General
