Rebar Scanner A60+
1
Chapter I Overview
1.1 Brief introduction
Rebar Scanner A60+ is used to detect current reinforced concrete
project and new reinforced concrete structure construction quality and
determine the location and layout of rebar. If the diameter is known, it
will be used to detect the thickness of concrete covering layer. If the
diameter is not known, it will be used to detect rebar diameter and
thickness of concrete covering layer at the same time. Besides, it
possesses the function of scanning path. And it can detect the location
of magnetic substance and electric conductor in non-magnetic and
non-conductive medium, e.g. cable inside wall body and water &
heating pipe etc. This instrument is a kind of intelligent nondestructive
test equipment possessing the functions of automatic detection, data
memory and output.
1.2 Main functions
1、 Detect the location and direction of rebar in concrete
structure；
2、Detect covering layer thickness of rebar (diameter is known)；
3、At the same time, estimate diameter of rebar and thickness of
covering layer；
4、Detect the thickness of covering layer under the same
measuring surface and display grid pattern image；
5、Detect the thickness of covering layer under the same
measuring line and display section plane image；
6、Self-calibration function of probe；
7、Memory and view of detected data；
To Next Page
Loading...