Rebar Scanner A60+
5
3.2.2 Interface of function selection
Press any key on start-up interface to enter into the interface of
function selection, as figure 3.2 shows. It includes functions of
Thickness Test detecting covering layer thickness, Diameter Test
detecting reinforced bar diameter, Rebar Scan detecting covering layer
thickness of grid pattern or multiple parallel rebar, Transfer Data,
View Data, and Delete Data ， through ↑ and ↓keys ， select
corresponding functions and press ENTER key to enter into
corresponding functional interfaces.
Figure 3-2 Interface of function selection
3.2.3 Thickness test
Interface of thickness test is shown as figure 3-3. Firstly, project
information is set. During setting, if Diameter (default is 16mm) and
No. (the initial position is fixed as 1) are known, press ← and →keys
to move the cursor and press ↑ and ↓keys to adjust the value of cursor
position. After above setting is end, press the ENTER key to confirm
the setting. Then probe is self-calibrated. At this time, probe should be
placed in the air and away from the strong magnetic field interference.
At the same time, wait！ is showed on the screen. After wait！is
missing, it indicates self-calibration of probe is end, as figure 3-4
Thickness Test
Diameter Test
Rebar scan
Transfer Data
View Data
Delete Data
To Next Page
Loading...