Twitoplast C210 - System Installation Instructions

C210 Controller & C680RF thermostats
3
General
• Install in accordance with all local codes
• DO NOT splice any wires, splicing wires will void the warranty
• Install as per the installation instructions provided.
• Therearenoeldserviceablecomponents,donotattempttorepair.
• For use on 120 VAC/ 60 HZ systems only.
• Anymisuseormodicationswillvoidthewarranty.
• Installationmustbemadebyaqualiedinstaller.
Caution
• To prevent electrical shock or equipment damage, disconnect the
power supply before installing and servicing the system.
• Prior to installation become familiar with the system and its operation.
System Installation Instruction:
Turn OFF all power supplies prior to installation.
Select a location for the controller at a secure area.
The controller should be installed centrally in the duct area.
Mount the controller securely to a wall or to the air condition chassis.
Connect the cable according to the below instruction and wiring diagram.
Apply power to the controller by connecting the 230 VAC / 12 Volts
transformer.