2018/06/02 11:40 23/28 Torpedo C.A.B. User's Manual
User's manuals - http://wiki.two-notes.com/
Note: with 3rd-party files you do not have access to microphone positioning parameters.
5 MIDI
Your Torpedo C.A.B. can receive MIDI Program Change (PC) and Control change (CC) commands sent
by any kind of MIDI controller connected to the MIDI IN of the machine.
It is important to setup the Torpedo C.A.B. so it will be listening to the MIDI
control commands. Please refer to the Setup section.
5.1 Program Change (PC)
Each preset on the Torpedo C.A.B. has a single program number. The preset 001 of the machine is
triggered by a MIDI PC 1, you can address the 128 presets, with MIDI PC 1 to MIDI PC 128. This way, it
is possible to randomly access the preset by sending the appropriate MIDI PC number.
5.2 Control change (CC)
The following table indicates the Control Change numbers for every parameter, as well as their range
and behavior.
Parameter CC# Range Behavior
Simulation mode
Power Amp
On/Off
0
0-1 0 = Off ; 1 = On
Model 1 0-7 0 = Model #0 ; 1 = Model #1…
Volume 2 0-30 0 = 0dB ; 30 = 30dB
Presence 3 0-127 0 = 0% ; 63 = 50% ; 127 = 100%
Depth 4 0-127 0 = 0% ; 63 = 50% ; 127 = 100%
Type 5 0-1 0 = Triode : 1 = Pentode
Miking
On/Off 6 0-1 0 = Off ; 1 = On
Mode 7 0-7 0 = Cab/Mic ; 1 = User 0 ; 2 = User 2 ; 3 = User 2 ; 4 = User 3
Cab 8 0-x 0 = Cab #0 ; 1 = Cab #1…
User 0 9 0-x 0 = File #0 ; 1 = File #1…
User 1 10 0-x 0 = File #0 ; 1 = File #1…
User 2 11 0-x 0 = File #0 ; 1 = File #1…
User 3 12 0-x 0 = File #0 ; 1 = File #1…
Mic 13 0-7 0 = Mic #1 ; 1 = Mic #1…
Distance 14 0-127 0 = 0% ; 63 = 50% ; 127 = 100%
To Next Page
Loading...