Two Notes TORPEDO Live User Manual

Configuring and using the TORPEDO Live
You will find three modules in the EDIT mode (Power Amp,
Miking and EQ), followed by the output volume of the pre-
set (this volume setting is saved with the preset, so you can
adjust the levels in order for the presets to be at comparable
volumes).
You will see on the first line of the screen the module name and its current state (On, Off, level in
dB for the OUTPUT LEVEL)
Navigate through the modules with the PARAMETER encoder. A module is activate when it’s On,
you can change the module state with the VALUE encoder. Once the module is On, you gain access
to the module parameters.
On a parameter page (change the page with the PARAME-
TER encoder), you will see on the first line the module name,
the parameter index and the number of parameters of the
module.
On the second line you will find the parameter name and its value. Change the value using the
VALUE encoder. The following tab contains the modules list, their parameters with the possible values.
All details about the parameters are below.
Module Parameter
Value
Power Amp
On or Off
Model
8 models, from SE 6L6 to PP KT88
Volume
0 to 30dB
Presence
If Model PP: 0 to 100%
Depth
0 to 100%
Type
Triode or Pentode
Miking
On or Off
Bank
Cab/mic, User 0 to User 3 (in User bank, the options Mic, Dis-
tance, Center and Position are not available). 32 memory
slots for Cab/mic, 128 per User bank
Cab or File
Cabinet name or IR file name
Mic
Microphone name
Distance
0 to 100% (i.e. 0 to 10 feet)
Center
0 to 100% (i.e. 0 to cabinet side, length depending on the
real cabinet geometry)
Position
Back or Front
EQ
On or Off
Mode
Guitar or Bass
120Hz (Guitar) or 50Hz (Bass)
-20dB to +20dB
360Hz/120Hz
-20dB to +20dB
800Hz/360Hz
-20dB to +20dB
2KHz/800Hz
-20dB to +20dB
6KHz/4KHz
-20dB to +20dB
Level
-95 to 0dB
Two Notes Audio Engineering TORPEDO Live 20

Two Notes TORPEDO Live Specifications

General

Brand	Two Notes
Model	TORPEDO Live
Category	Recording Equipment
Language	English