Two Notes Torpedo Reload - Page 48

Specifications
Designation
Characteristics
REPLAY™ Input
Jack 6.35mm (1/4") balanced (TRS, Tip/Ring/Sleeve)
Maximum input level: 36 dBu
Input impedance: 20 KOhms
Ground/Lift switch
REPLAY™ Output
Jack 6.35 mm (1/4") unbalanced (TS)
Impedance: 300 Ohms
Gain (In to Out): 0 to -inf dB, adjustable by potentiometer
Maximum output level: 19 dBu
Noise: under -98 dBu from 20 Hz to 20 KHz
Frequency response @ -1dB: 0 Hz to 18 kHz
DI Input
Jack 6.35 mm (1/4") unbalanced (TS, Tip/Sleeve)
Impedance : 1 MOhms
DI Output
Balanced male XLR
Impedance: 600 Ohms
Ground/Lift switch
Gain (In to balanced Output): 6 dB
Maximum in/out level: 20 dBu
Noise: under -98 dBu from 20 Hz to 20 kHz
Frequency response @ -1dB: 0 Hz to 18 kHz
Thermal security
Cooled by temperature-controlled fan
Thermal security: when overheating, the loadbox gets disconnected (leaving only a 220-
Ohm security load) and the signal is muted.
Power supply
IEC60320 C14 power connector
Input voltage: depending on your country of residence, from 100V to 230V, 50 to 60Hz
Power: approx. 100 W Max
Dimensions
Width: 320 mm
Depth: 178 mm, 200 mm including connectors and knobs
Height: 89 mm
Weight: 4.5 kg
48 Two Notes Audio Engineering Torpedo Reload