Note: After clamping into the slot, tighten the screws.
After tightening, the long side of the T-nut should be parallel to the horizontal plane.
注意： 卡入槽中后，再拧紧螺钉。拧紧螺丝后，T型螺母的长边应与水平面平行
6. Install The Heating Plate Supports 安装热床支架
Heating Plate Support
热床支架
x2
M3*6 Screw 螺丝
x8
Note: Do not over tight first in case you need to adjust such as installing crookedly
注意： 一开始不要扭太紧，以防之后因为装歪而需要调整这里。
SP-59 TWOTREES
To Next Page
Loading...