Err1: The heating plate exceeds the maximum temperature limit, please check
whether the thermal interface is shorted.
热床超过最大温度限制，请检查热接口是否短接;
Err2: The nozzle exceeds the maximum temperature limit, please check whether
the thermal interface is shorted.
喷嘴超过最大温度限制，请检查热接口是否短接;
Err3: The heating plate is below the minimum temperature limit, please check
whether the thermal interface is disconnected.
热床低于最低温度限制，请检查热接口是否断开;
Err4: The nozzle is below the minimum temperature limit, please check whether
the thermal interface is disconnected.
喷嘴低于最低温度限制，请检查热接口是否断开;
Err5: The heating of the nozzle fails. If the nozzle does not reach the set
temperature difference within the set time an error will be reported; please
check the configuration file settings or check whether the power supply is
sufficient.
喷嘴加热失败： 如果喷嘴在设定时间内未达到设定的温差，则报错：请检查配置文件设置
或检查电源攻率是否足够;
Err6: The heating of the heating plate fails. If the heating plate reaches the set
temperature difference within the set time, an error will be reported; please
check the configuration file settings or check whether the power supply is
sufficient.
热床加热失败： 如果热床在设定时间内达到设定的温差，将报告错误：请检查配置文件设
置或检查电源攻率是否足够;
E r r7: Thermal runaway. When the temperature reaches the target temperature, the
current temperature is lower than the target temperature value within the
set time and exceeds the set temperature, an error will be reported; please
check whether the thermal sensitivity is normal or whether the PID value is
appropriate.
热失控: 当温度达到目标温度时，当前温度低于设定时间内的目标温度值超过了设定温
度时，则报错。请检查热敏是否正常或PID值是否合适。
ERROR SYMBOLS & DEFINITION
错误标志与定义
SP-5 24TWOTREES
To Next Page
Loading...