8.2. “Back” → “Extrusion” → “10”mm，Normal，In
返回 → 挤出 → 10mm， 中速， 推进
8.3. See if the filament is extruded smoothly and
evenly
看耗材是否顺滑均匀挤出
9. Try Printing 尝试打印 ：
“Printing” → “TEST-XY2020.gcode” → “Confirm”
打印 → TEST-XY2020.gcode → 确认
10. Second Check 二次检查：
Touch the material just extruded. If it is not easy
to be scraped, leveling is done. Otherwise, it
needs to be adjusted by rotating the nuts
用手碰刚挤出的耗材，不易脱落的则调平成功，不然
需旋转螺母调整
Normal
SP-523 TWOTREES
To Next Page
Loading...