7. Assemble Filament 耗材装配 ：
7.1. Insert the Teflon tube into the joint.
Note： Ensure you really plug it 5-6 cm to the bottom
四氟管插入到底，确保插到底
7.2. Insert the filament through the filament sen
sor and BGM extruder.
耗材穿过断料检测和BGM挤出机
8. Test The Output 检测耗材输出：
8.1. “Preheat” → Choose among “1/5/10℃” (Click to
change) → “Add” (Click the “Add” to increase the
temperature that the filament needs, generally
around 200℃).
“预热”→ 选择“1/5/10℃”（点击可更换）→ “增加”（点击
“增加”，增加到耗材所需的温度，一般在200℃左右）。
6. Leveling： 调平
6.1. “Leveling” → click 5 points and
level them one by one
依次点击5个点
6.2. Insert a piece of A4 paper to see if it can
slide smoothly, otherwise there is a scratch
and you need to rotate the nuts manually
塞一张A4纸，看是否能滑动，如纸上有刮痕,需要手动旋转螺母
SP-5 22TWOTREES
To Next Page
Loading...