23
Internet Alarm Communicator Installation Manual
[021] Account Code
Default (FFFFFF)
The account code is included when transmitting any events generated by the communicator. (e.g.,
panel absent trouble). It is recommended that the account code be the same as the control panel
account number. Valid range: 000001-FFFFFE. If 4 digit account codes are needed the 2 lowest
digits must be programmed as FF (e.g., Account 1234 is programmed as:1234FF).
NOTE: Programming this section with all 0 or F will cause a module configuration trouble.
NOTE: This section shall sync with panel option [310] with PowerSeries Neo panels version 1.00
or higher.
[022] Communications Format
Default (04)
Program 03 for Contact ID (CID). Program 04 for SIA. The module can be configured to send
Events in SIA or CID format. The SIA communication format follows the level 2 specifications of
the SIA Digital Communication Standard - October 1997. This format will send the account code
along with its data transmission. The transmission will look similar to the following at the
receiver.
NOTE: This section shall sync with PowerSeries Neo panels version 1.00 or higher.
Example:
Nri0 ET001 where: N = New Event; ri0 = Partition/Area identifier; ET = Panel Absent Trouble;
001 = Zone 001.
61 12
NZST New Zealand Standard Time
FJT Fiji Time
WFT Wallis and Futuna Time
TVT Tuvalu Time
PETT Petropavlovsk Time
NRT Nauru Time
MHT Marshall Island Time
GILT Gilbert Island Time
ANAT Anadyr Time
64 12.75 CHAST Chatham Island Standard Time
65 13
PHOT Phoenix Island Time
TOT Tonga Time
69 14 LINT Line Island Time
70 - FF N/A Reserved
Table 8: World Wide Time Zones
HEX
Valu e
Offset
Hours
Std
Abbrev
Location
To Next Page
Loading...
Need help?
General
