Tyco FlameVision FV300 SERIES - Page 64

ANNEX B - CCTV DETAILS
63
If the detector also has an OPM condition or fault to report then this will move to the line below
the hardware fault.
B 1.5 OTHER MESSAGES
There are a few messages that can appear towards the bottom of the quiescent mode text overlay
to report other states of the detector.
Fig. B-5 shows the position of other message fields on the text overlay.
The log counter will be displayed when an event occurs to show where it is recorded in the internal
log.
Fault Message Description and How to fix it
Wiring fault
A fault has been detected on the circuit from
the detector. Check wiring.
Detector fault
The detector has an internal fault. Record the
model and serial number and contact your
supplier.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
1
2
3
4
5
6
7
8
9
10
11
12
FlameVision
< CAMERA STATE >
< L O C A T I O N AND IDENTITY >
<SETTLE>
< SERVICE STATE >
<D>
<W >
<M>
<O>
< Log Counter>
Fig. B-5 Other Detector States Overlay
www.acornfiresecurity.com
www.acornfiresecurity.com