A3
N
of
PART No:
ECO DATEAPVDAUTH
CHKD
DRNAMENDMENTSISS/REV
ISS/REV
SHEET
DRAWING No:
ALL DIMENSIONS IN MILLIMETRES. DO NO T SCALE. TOLERANCES ARE TO BE:
1 DECIMAL PLACE #0.5, 2 DECIMAL PLACES #0.3, 3 DECIMAL PLACES #0.1
UNLESS OTHERWISE STATED:
3rd ANGLE
PROJECTION
THIS DOCUMENT MUST NOT BE COPIED NOR THE CONTENTS PASSED
ON TO ANY THIRD PARTY WITHOUT THE CO NSENT OF THE COMPANY.
CONFIDENTIAL:
JOHNSON CONTROLS
CHRISTCHURCH,
+64 3 3895938
+64 3 3895096PH:
17 MARY MULLER DRIVE
P.O. BOX 19545
FAX:NEW ZEALAND.
© 2017 Johnson Controls. All rights reserved.
All specifications and other information shown
were current as of document revision date and
are subject to change without notice.
A ORIGINAL 5053 KJS RC RC DC
9-8-17
B T-GEN 60 SIDE FOLD MTG ADDED. 5142 KJS PV RC DC
15-10-18
B
1982-71 169
MX1
T-GEN2, 100V SWITCH/SPLITTER
GEARPLATE POSITIONS
NOTES:
1. MOUNT T-GEN 60 USING 5 PLASTIC STAND-OFFS (HW0130)
AND 1 OFF M3 X12 SCREW (SC0177). STAND-OFFS FACTORY
FITTED FROM GEAR PLATE REAR.
2. MOUNT T-GEN 60 ON SIDE FLANGE USING 2 OFF M3 M/F
BARREL NUTS (FA2552) AND 2 OFF M3 X 6 SCREWS (SC0172)
FITTED TO J19 AND J26. 4 PLASTIC DOUBLE BARB PCB
STAND-OFFS (HW0052) ARE FITTED TO THE 4 REMAINING
HOLES. BARREL NUTS AND PLASTIC DOUBLE BARB PCB
STAND-OFFS ARE FITTED FROM SIDE FLANGE FRONT.
3. MOUNT T-GEN 120 WITH 4 OFF M4 X10 SCREWS
(SC0176) USING M4 LOOP CARD BRACKET MOUNTING
HOLES IN GEAR PLATE.
4. MOUNT EACH 100V SWITCHING OR SPLITTER MODULE
WITH 2 OFF M4 X10 SCREWS (SC0176) USING M4 LOOP
CARD BRACKET MOUNTING HOLES IN GEAR PLATE.
MAINS
SOCKET
MX1 POWER SUPPLY
MX1 CONTROLLER
T-GEN 60/120
100V SWITCHING OR
SPLITTER MODULES
SECTION A-A
ISOMETRIC VIEW
SCALE 0.200
To Next Page
Loading...
