EasyManuals Logo

Tylo H1 User Manual

Tylo H1
9 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
Setting the desired level of humidity (Combi Compact only)
Press the Up or Down arrow to highlight the humidity symbol (16) and press OK. Set the
desired level of humidity on the scale that runs from 0–10: 0 = a dry sauna, 10 =
maximum humidity.
The water level in the tank is indicated by the water droplet icon in the status display. An
illuminated, fully filled water droplet indicates a full tank. An illuminated, half-filled icon
indicates that the tank is half full. A flashing, empty icon indicates that the tank is empty.
When starting a bathing cycle, an empty tank is also indicated by a repeated audible
signal. If the water runs out during the bathing cycle, this is indicated by a flashing icon
and a repeated audible signal. As the tank is gradually refilled with water, the icon
changes from half-filled to full and a single audible signal sounds to indicate that the tank
is full once again.
Drying mode (Combi Compact only)
When the preset running time has elapsed or the heater is switched off by pressing the
OFF button, the sauna heater switches automatically to drying mode (provided that the
water tank has been in use and the humidity level has been set at a value from 1 to 10).
The drying cycle runs for 20 minutes and then the heater switches off. The drying cycle
can also be terminated manually by pressing the OFF button.
To show that the drying mode is in operation, the ON icon is replaced by the drying
mode icon.
Setting the desired start time
You can set a start time for the sauna heater or steam generator up to 24 hours in
advance.
To preset a start time, use the Up and Down arrows to mark the clock symbol (3) and
press OK. Select Start time, then preset the desired time by using the Up and Down
arrows. Confirm each individual figure by pressing OK. A clock icon will light up in the
status display to indicate that a start time has been programmed.
A time that has already been programmed can be activated by stepping to Activate
under the clock symbol and confirming with OK.
To deactivate a programmed value, step to (3), use the Down arrow to step to Activate
and confirm with OK.
English
15

Other manuals for Tylo H1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tylo H1 and is the answer not in the manual?

Tylo H1 Specifications

General IconGeneral
BrandTylo
ModelH1
CategoryControl Panel
LanguageEnglish

Related product manuals