Floor panel (Box 1): Put the floor panel on a level surface 8-16 cm from the wall panel and no more
than 152 cm away from a 230V socket.
Position the floor panel in such a way that the ceramic tiles/ IR floor heating point towards the front
of the sauna.
Note: Put the ceiling, bench valance and bench aside until the corresponding steps.
Rear wall panel (Box 2):
• Place the rear panel section into the rear slot on the floor panel.
• The back wall panel section must be held upright until the right wall panel is fitted.
• Connect the electrical supply to the B-1 junction box.
• Fix the cover of the B-1 junction box with 2 Phillips screws.
Note – Put the front panel aside until the “Front panel” section.
Page 4
To Next Page
Loading...
