3PersonInfraredSaunaCottage Page19 210121
Rev.2
IR2 Control Operation
Operating Instructions
Default settings for temperature are preset to 65°C, the time is set to 60
minutes. These settings are adjustable as described below. Any changes
are remembered by the room for your next bath. Should the room power be
lost then restored, the settings will return to their default values.
STARTING IR2
Press the start icon once.
The default setting is that all heaters are active. You have the possibility to
turn on/off heaters by pressing (floor), (skirt) and/or (bench). The
wall heaters are always on when start button is activated.
SETTING THE TIME AND TEMPERATURE
To set the sauna length time, press the icon and then press the “"+" or "-"
icons to increase or decrease time for desired setting. The maximum of time
is 60 minutes.
To set the temperature, press the and next "+" or "-" icons to increase or decrease temperature for desired setting.
The minimum temperature is 25°C and maximum temperature is 65°C.
Operating Instructions for Lighting
Press icon to cycle through lighting options. Press and hold the
icon for 3 seconds to turn off the lights.
Lights will turn off automatically 10 minutes after sauna cycle is completed.
- Color sequence – White – Red – Green – Blue – Yellow – Aqua – Purple – Rotation of Colors – Off
Choose the color of choice and then set lighting brightness. The brightness will be on display for 3 seconds. Press the
“+” or “-“ icon to increase or decrease the light setting. Setting options are 25, 50, 75, and 100% light output.
AUDIO OPERATION
Audio Power On
Press icon to toggle On or Off the Bluetooth System.
Note: The control does not have to be active for Sound System to operate.
To Next Page
Loading...
