▶ Creep speed(attained by shifting the creep gear shift lever to OFF) should be used only when
doing one of the following jobs:
1.Deep rotary-tilling and harrow
2.Planting
3.Turf application.
▶ Creep speed should not be used for any of the following:
1.Pulling a trailer
2.Front loader operation
3.Front blade operation
4.Earth-moving
5.Entering and leaving a field
6.Loading onto and unloading from a truck
▶ To avoid personal injury:
○ When you leave the tractor,be sure to apply the parking brake and stop the engine
○ In applying the brakes:
-The torque of wheel axle is extremely high while creep speed is being used.Be sure to step down
on the clutch pedal completely before applying the brakes,or they will not work.
-When starting to operate the tractor,be sure to release the parking brakes.Misuse of the brakes may
cause damage to the transmission and is therefore not acceptable to TYM for coverage under the
▶ Diff-lock pedal
In case of wheel slippage use the diff-lock by pushing
down on the diff lock pedal.
To release it remove the foot from the pedal.
Tractor will be difficult to turn if the Diff-
lock is engaged, ensure the lock is
disengaged before turning the steering wheel.
Danger
43
Press the clutch pedal completely down and stop the tractor’s motion before shifting the
creep speed gear lever.
Important
Do not use high engine RPM when engaging Diff lock If the diff lock does not
release after removing the foot from the diff lock pedal alternatively brake with the
left and right brake until it gets released.
important
To Next Page
Loading...
