TYM T700 - Section A: Controls, Instruments and Operations; Introduction to Controls

SAFETY SIGNS
(Replace all missing, damaged or illegible signs)
GENERAL SAFETY INFORMATION
IMPORTANT: This “General safety Information” should be kept with the machine at all times as
f
d
re
f
erence
d
ata.
This symbol means ATTENTION! YOUR SAFETY IS INVOLVED.
The message that follows the symbol contains important information about
safety. Follow recommended precautions and safe operating practice.
WARNING
• Before starting and operating know the operating
and safety instructions in the operators Manual
and
on
the
tractor
• Do not permit anyone but the operator to
ride on the tractor. There is no safe place
for rider.
and
on
the
tractor
• Clear the area of bystanders.
• Locate and know operation of the controls.
• Start the engine only from Operator’s seat with
depressed clutch pedal, transmission in the
neutral, PTO disengaged and hydraulic control in
lower position
• Slow down on turns, rough ground and slopes to
for
rider.
• Lock brakes together, use warning lights
and SMV emblem while driving on roads.
• Lower equipment, place gear shift levers
in neutral, stop engine, remove the key
and apply parking brake before leaving
the tractor seat.
• Air pressures are specified by the
avoid rollovers. manufacturer in the tires
FAILURE TO FOLLOW ANY OF THE INSTRUCTIONS ABOVE CAN CAUSE SERIOUS INJURY
TO THE OPERATOR.
25