STOPPING THE ENGINE
-After light work let the engine idle for a while and turn the key off.
After long or heavy work allow the engine to idle for 5- 10 minutes and turn the key off.
WARMING UP
When starting the engine allow it to warm up to operating temperature by allowing it to idle 5-10 minutes to
ensure full lubrication and operating temperature.
Failure to do so can shorten engine life substantially.
▶WARMING UP IN COLD WEATHER
Cold weather will change the viscosity of the oil, resulting in a reduced oil pumping capacity, which can
cause damage to the engine if it is not warmed up correctly.
It also causes problems with the hydraulic system and the synchromesh in the transmission.
Correct times for warming up are:
Temperature Time for warming up
Above 50°F
5~10 min.
50°F~ 32°F
10~20 min.
32°F~14°F
20~30 min.
14°F~-4°F
30~40 min.
Below –4°F
Over 40 min.
Ensure the handbrake (Foot brake) is on during the warming period.
Failure to warm up correctly can result in problems.
When the engine is warm push down the clutch and engage the main and auxiliary gear levers to the
required position.
Push down on the brake pedals and release the handbrake.
Important
57
Increase the engine revolutions and let out the clutch smoothly.
Only change gears with main gear lever while moving and ensure that this is done with fully use of the
clutch.
To Next Page
Loading...
