TYM T700 - Cabin Features and Operation; Cabin Overview and Versions

SERVICING THE AIR CLEANER
To remove the dust from the evacuator valve squeeze it between
thumb and fingers to let excess dust out and wipe around the
valve to keep it clean from outside.
To clean the main element, remove the right engine cover.
Remove the element by undoing the wing nut.
Rdbbliifhl ih d
R
emove
d
ust
b
y
bl
ow
i
ng
i
t out o
f
t
h
e e
l
ement w
i
t
h
compresse
d
air.
Check the element to ensure it is not damaged.
Reassemble the element.
Use a light inside the element to ensure it is not damaged.
Never beat the element on a stone or concrete floor/wall to clean it Check all connections
and hoses especially on the clean side of the air cleaner to ensure no dusty air can enter the
engine.
Check the element for flaws by putting a light inside the element.
When reassembling make sure all surfaces seal correctly to keep dust out.
When working in dusty conditions increase the service frequency.
▶Replace the element after cleaning it 5 times or it is damaged.
CHECKING HOSES AND LINES
.
important
The fuel lines, radiator hoses, hydraulic and rubber hoses are consumables, which deteriorate by age and
use.
Check them regularly and replace if faulty.
Damaged fuel lines leak and cause fires.
Damaged radiator hoses can cause hot water burns and in severe cases seize the engine.
Caution
CHECKING THE WIRING HARNESS AND FUSES
Loose wires make inferior connections and damaged wires can cause short circuits, fires burnt wiring or
reduce efficiency of components.
Replace or repair any faulty wiring or insulation.
If a fuse burns out a
g
ain after it has been re
p
laced
,
do not re
p
lace it with wire or a hi
g
h ca
p
acit
y
fuse
,
find
81
gp,p gpy,
the cause and rectify it or get an auto electrician to do so.
Where insulation is chafed or peeled off, recover the area with a good quality insulation tape. Where
wiring comes out of it’s fitting replace it correctly with the standard fitting.