TypeS POWERGEN 500 - REPAIR Mode

7
For charging 12V Li-ion batteries rated at 5A
PUSH mode
PUSH Mode
REPAIR mode
PUSH
LI-ION
12V 5A
Push Mode is designed for charging battery with voltage in between 0.5V
to3.75V.popupandashwhenbatteryisconnectedandlow
voltage is detected. You need to press and hold the SELECT button for 3
secondstoenterPushMode,lightupandashatthesame
time. Press and hold the SELECT button for 3 seconds to start, the battery
will be charged with maximum current of 0.5A until the voltage is over
3.75V and it will enter the selected charge mode for charging onwards.
12V Repair Mode is designed for 12V LEAD-ACID BATTERIES ONLY.
Itisabatteryrecoverymodeforrepairing&restoringdamaged,stratied
and sulphated batteries. The lights up and charging starts. The
recovery process will take one to four hours and the battery will be charged
in 12V 5A mode if recovery is successful.
PUSH
PUSH
6V 12V
REPAIR Mode